This is a purely informative rendering of an RFC that includes verified errata. This rendering may not be used as a reference.

The following 'Verified' errata have been incorporated in this document: EID 274, EID 275
Network Working Group                                          R. Sparks
Request for Comments: 3420                                   dynamicsoft
Category: Standards Track                                  November 2002

                  Internet Media Type message/sipfrag

Status of this Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2002).  All Rights Reserved.


   This document registers the message/sipfrag Multipurpose Internet
   Mail Extensions (MIME) media type.  This type is similar to
   message/sip, but allows certain subsets of well formed Session
   Initiation Protocol (SIP) messages to be represented instead of
   requiring a complete SIP message.  In addition to end-to-end security
   uses, message/sipfrag is used with the REFER method to convey
   information about the status of a referenced request.

Table of Contents

   1.  Introduction . . . . . . . . . . . . . . . . . . . . . . . . .  2
   2.  Definition: message/sipfrag  . . . . . . . . . . . . . . . . .  2
   3.  Examples . . . . . . . . . . . . . . . . . . . . . . . . . . .  3
       3.1 Valid message/sipfrag parts  . . . . . . . . . . . . . . .  3
       3.2 Invalid message/sipfrag parts  . . . . . . . . . . . . . .  4
   4.  Discussion . . . . . . . . . . . . . . . . . . . . . . . . . .  5
   5.  IANA Considerations  . . . . . . . . . . . . . . . . . . . . .  6
   6.  Security Considerations  . . . . . . . . . . . . . . . . . . .  6
       Normative References . . . . . . . . . . . . . . . . . . . . .  7
       Non-Normative References . . . . . . . . . . . . . . . . . . .  7
       Author's Address . . . . . . . . . . . . . . . . . . . . . . .  7
       Full Copyright Statement . . . . . . . . . . . . . . . . . . .  8

1. Introduction

   The message/sip MIME media type defined in [1] carries an entire well
   formed SIP message.  Section 23.4 of [1] describes the use of
   message/sip in concert with S/MIME  to enhance end-to-end security.
   The concepts in that section can be extended to allow SIP entities to
   make assertions about a subset of a SIP message (for example, as
   described in [6]).  The message/sipfrag type defined in this document
   is used to represent this subset.

   A subset of a SIP message is also used by the REFER method defined in
   [5] to carry the status of referenced requests.  Allowing only a
   portion of a SIP message to be carried allows information that could
   compromise privacy and confidentiality to be protected by removal.

   This document does NOT provide a mechanism to segment a SIP message
   into multiple pieces for separate transport and later reassemble.
   The message/partial type defined in [2] provides a solution for that

   The key words "MUST", "MUST NOT", REQUIRED", "SHALL", "SHALL NOT",
   document are to be interpreted as described in [4].

2. Definition: message/sipfrag

   A valid message/sipfrag part is one that could be obtained by
   starting with some valid SIP message and deleting any of the

   o  the entire start line

   o  one or more entire header fields

   o  the body

   The following Augmented Backus-Naur Form (ABNF) [3] rule describes a
   message/sipfrag part using the SIP grammar elements defined in [1].
   The expansion of any element is subject to the restrictions on valid
   SIP messages defined there.

           sipfrag = [ start-line ]
                     [ CRLF [ message-body ] ]

   If the message/sipfrag part contains a body, it MUST also contain the
   appropriate header fields describing that body (such as Content-
   Length) as required by Section 7.4 of [1] and the null-line
   separating the header from the body.

3. Examples

3.1 Valid message/sipfrag parts

   This section uses a vertical bar and a space to the left of each
   example to illustrate the example's extent.  Each line of the
   message/sipfrag element begins with the first character after the "|"

   The first two examples show that a message/sipfrag part can consist
   of only a start line.

         | INVITE SIP/2.0
         | SIP/2.0 603 Declined

   The next two show that Subsets of a full SIP message may be

      | REGISTER SIP/2.0
      | To:
      | Contact: <>;q=0.9,
      |          <>;q=0.1

      | SIP/2.0 400 Bad Request
      | Warning: 399 Your Event header field was malformed

   A message/sipfrag part does not have to contain a start line.  This
   example shows a part that might be signed to make assertions about a
   particular message.  (See [6].)

         | From: Alice <>
         | To: Bob <>
         | Contact: <>
         | Date: Thu, 21 Feb 2002 13:02:03 GMT
         | Call-ID: a84b4c76e66710
         | Cseq: 314159 INVITE

   The next two examples show message/sipfrag parts that contain bodies.

         | SIP/2.0 200 OK
         | Content-Type: application/sdp
         | Content-Length: 247
         | v=0
         | o=alice 2890844526 2890844526 IN IP4
         | s=
         | c=IN IP4
         | t=0 0
         | m=audio 49170 RTP/AVP 0
         | a=rtpmap:0 PCMU/8000
         | m=video 51372 RTP/AVP 31
         | a=rtpmap:31 H261/90000
         | m=video 53000 RTP/AVP 32
         | a=rtpmap:32 MPV/90000

         | Content-Type: text/plain
         | Content-Length: 11
         | Hi There!

3.2 Invalid message/sipfrag parts

   This section uses the character "X" followed by a space to the left
   of each example to illustrate the example's extent.  Each line of the
   invalid message/sipfrag element begins with the first character after
   the "X " pair.

   The start line, if present, must be complete and valid per [1].

         X INVITE

         X INVITE SIP/1.09

         X SIP/2.0

         X 404 Not Found

   All header fields must be valid per [1].

         X INVITE SIP/2.0
         X Via: SIP/2.0/UDP ;branch=z9hG4bK29342a
         X To: <>;tag=39234

         X To:
         X From:;tag=1992312

         X Call-ID: this is invalid

         X INVITE SIP/2.0
         X From: <>;tag=z9hG4bK2912;tag=z9hG4bK99234

   If a body is present in the message/sipfrag part, the headers
   required by Section 7.4 of [1] and the null-line separating the
   header from the body.

         X MESSAGE SIP/2.0
         X Hi There!

4. Discussion

   Section 23 of [1], and memos [5] and [6] provide motivation and
   detailed examples of carrying all or part of a SIP message in a MIME
   part.  Briefly, using this representation along with S/MIME enables
   protecting and making assertions about portions of a SIP message
   header.  It also enables applications to describe the messaging
   involved in a SIP transaction using portions of the messages

   The SIP REFER method [5], for instance, uses this to report the
   result of a SIP request to an authorized third party.  However, as
   that document details, it is rarely desirable to include the entire
   SIP response message in this report as a message/sip MIME part.
   Doing so has significant negative security implications.  The
   message/sipfrag type, on the other hand, allows a sender to select
   what information is exposed.  Further, it allows information required
   in a full SIP message that is not pertinent to a description of that
   message to be elided, reducing message size.  For instance, this
   allows a SIP element responding to a REFER to say "I got a 400 Bad
   Request with this Warning header field" without having to include the
   Via, To, From, Call-ID, CSeq and Content-Length header fields
   mandatory in a full SIP message.

   The message protection mechanism discussed in Section 23 of [1]
   assumes an entire SIP message is being protected.  However, there are
   several header fields in a full SIP message that necessarily change
   during transport.  [1] discusses how to inspect and ignore those
   changes.  This idea is refined in [6] to allow protection of a subset
   of the entire message, avoiding the extra work and potential errors
   involved in ignoring parts of the message that may legitimately
   change in transit.  That document also describes constructing
   cryptographic assertions about pertinent subsets of a SIP message
   header before the full header (including hop-by-hop transport
   specific information) may be available.

5. IANA Considerations

   The message/sipfrag media type is defined by the following

   Media type name: message
   Media subtype name: sipfrag
   Required parameters: none
   Optional parameters: version
     Version: The SIP-Version number of the enclosed message (e.g.,
     "2.0"). If not present, the version defaults to "2.0".
   Encoding scheme: SIP messages consist of an 8-bit header optionally
     followed by a binary MIME data object. As such, SIP messages must
     be treated as binary. Under normal circumstances SIP messages are
     transported over binary-capable transports, no special encodings
     are needed.
   Security considerations: see below

6. Security Considerations

   A message/sipfrag mime-part may contain sensitive information or
   information used to affect processing decisions at the receiver.
   When exposing that information or modifying it during transport would
   do harm, its level of protection can be improved using the S/MIME
   mechanisms described in section 23 of [1], with the limitations
   described in section 26 of that document, and the mechanisms
   described in [6].

   Applications using message/sipfrag to represent a subset of the
   header fields from a SIP message must consider the implications of
   the message/sipfrag part being captured and replayed and include
   sufficient information to mitigate risk.  Any SIP extension which
   uses message/sipfrag MUST describe the replay and cut and paste
   threats unique to its particular usage.  For example, [6] discusses
   how a subset of a SIP message can be used to assert the identity of
   the entity making a SIP request.  The draft details what information
   must be contained in the subset to bind the assertion to the request.

Normative References

      [1]  Rosenberg, J., Schulzrinne, H., Camarillo, G., Johnston, A., 
        Peterson, J., Sparks, R., Handley, M. and E. Schooler, "SIP:
        Session Initiation Protocol", RFC 3261, June 2002.
EID 274 (Verified) is as follows:

Section: 99In Normative References, it says:

Original Text:

   [1]  Rosenberg, J., Schulzrinne, H., Camarillo, G., Johnston, A.,
        Peterson, J., Sparks, R., Handley, M. and E. Schooler, "SIP:
        Session Initiation Protocol", RFC 3265, June 2002.

Corrected Text:

   [1]  Rosenberg, J., Schulzrinne, H., Camarillo, G., Johnston, A.,
        Peterson, J., Sparks, R., Handley, M. and E. Schooler, "SIP:
        Session Initiation Protocol", RFC 3261, June 2002.
[2] Freed, N. and N. Borenstein, "Multipurpose Internet Mail Extensions (MIME) Part Two: Media Types", RFC 2046, November 1996. [3] Crocker, D. and P. Overell, "Augmented BNF for Syntax Specifications: ABNF", RFC 2234, November 1997. [4] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. Non-Normative References [5] Sparks, R., "The SIP Refer Method", Work in Progress. [6] Peterson, J., "Enhancements for Authenticated Identity Management in the Session Initiation Protocol (SIP)", Work in Progress. Author's Address Robert J. Sparks dynamicsoft 5100 Tennyson Parkway Suite 1200 Plano, TX 75024 EMail: Full Copyright Statement Copyright (C) The Internet Society (2002). All Rights Reserved. This document and translations of it may be copied and furnished to others, and derivative works that comment on or otherwise explain it or assist in its implementation may be prepared, copied, published and distributed, in whole or in part, without restriction of any kind, provided that the above copyright notice and this paragraph are included on all such copies and derivative works. However, this document itself may not be modified in any way, such as by removing the copyright notice or references to the Internet Society or other Internet organizations, except as needed for the purpose of developing Internet standards in which case the procedures for copyrights defined in the Internet Standards process must be followed, or as required to translate it into languages other than English. The limited permissions granted above are perpetual and will not be revoked by the Internet Society or its successors or assigns. This document and the information contained herein is provided on an "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Acknowledgement Funding for the RFC Editor function is currently provided by the Internet Society.
EID 275 (Verified) is as follows:

Section: 99The "short title" in the page headings, is missing an 's'.  

It currently says:

Original Text:

Internet Media Type message/ipfrag  

Corrected Text:

Internet Media Type message/sipfrag